Controlador: Laserworld USB interface Driver (before 2013)

Driver for the old Laserworld USB Interface for Showeditor versions 2011 and older. These drivers are officially compatible for all Windows versions up to and including Windows 7, but they run on Windows 8 and Windows 10, too! If you are using Windows 8, 8.1 or 10, you must follow this insctruction first: Before beginning with the installation, save your work and close all open windows. Press "Windows-Button + R" Type shutdown.exe /r /o /f /t 00 in the opening "run"-window. Click "OK" Windows will restart and now shows the "Options menu" Click "Troubleshoot" Then click "Advanced options" on the new window Now click „startup settings“ on the new window Press „reboot“ on the new window Windows will restart and now you can choose between various options which can be entered by pressing the respective number key. Click the number key for "Disable driver signature enforcement" After another restart, you will be able to install the Laserworld USB Interface driver After following the steps above or when you are using Windows 7 or lower, follow this instruction: Install the USB driver for the Laserworld USB interface (as seen above) Install Showeditor 2015 Install the ShowNET Interface (How to install the ShowNET interface) Run Showeditor 2015 A message appears, telling you the dongle key of your Laserworld USB is not suitable for this software. Click on OK, then... ... a request appers, if this message should appear again. Click on NO. Showeditor 2015 will run as usual and both interfaces can be used together. If the error report ever appears again, the ShowNET interface with the Showeditor 2015 license might not be installed properly. Installation and Usage at your own risk!